Suits Mercedes A6420780149 / 6420780149. Please provide your VIN to ensure the correct part for your vehicle is dispatched. This part must be fitted by a qualified diesel mechanic. Hi Tech Diesel Injection was established in 1998 and employs 16 staff. Hi Tech Diesel Injection are specialists in offering repair, service and parts for diesel fuel injection and turbochargers. We are also a Garrett authorised centre and achieved the Capricorn Million Dollar Supplier Award in 2012. Fuel Injection Pumps – Hi Tech Diesel Injection satisfy the rigorous standards of diesel fuel injection manufacturers such as Bosch, Denso and Delphi. Pressurised rooms are used to repair most common fuel injection products and a clean room has been installed for specialised repairs. Injectors – servicing of injectors is our specialty, whether it is a single or dual spring application. All injectors are repaired using genuine parts set to manufacturers specifications. Qualified Technicians – are factory trained by fuel injection manufacturers in the latest techniques to ensure that quality standards are achieved. This offers peace of mind knowing that experienced technicians are repairing your product. Diagnostic and Troubleshooting – including dyno and scan tools. Terms and Conditions of Sale of Parts? Hi Tech Diesel Injection Pty Ltd. Unless otherwise stated in our Quotation or agreed in writing, it must be clearly understood that acceptance of your Order is subject to acceptance of our standard conditions printed below. We cannot accept responsibility for any delays due to causes outside our control. Extra charges will apply to specially procured items. All claims for missing items must be made to our Company within 24 hours of receiving goods. We do not accept any responsibility for loss or breakage of goods in transit. Original invoice number and date must be quoted. Credits may be allowed at our discretion only upon the following conditions. (d) Goods “especially procured” to customer order must be confirmed by an Order in writing and are not eligible for return or credit. Customer’s property supplied to us will be held entirely at the customer’s risk as regards to fire or other unforeseen damage, unless otherwise arranged. Every care will be taken to get the best results where materials are supplied by the customer, but we do not accept responsibility for imperfect work caused by defective or unsuitable materials so supplied. Our quotation covers only the equipment listed in the Basic Specification of Equipment offered. All descriptive material, drawings, particulars of weights and dimensions submitted with our quotation are approximate. Certified information for installation purposes will be supplied on request. Any performance figures given by us in our quotation are based upon normal design experience and are such as we expect to obtain on test. We will, however, accept no liability if these figures are not obtained, unless they are specifically guaranteed in writing in which case they would be subject to the recognised tolerance and rejection limits applicable to such figures. We shall not be subject to nor incur any claim, action or liability for consequential damage, loss of use or of profits. Please ensure you are ordering correctly. If in doubt, supply a VIN to ensure the correct part is being supplied as goods will not be credited for incorrectly ordered parts or you changed your mind. All our parts are id stamped before we send them. If a part is found to be not working correctly within 7 days of receipt by the purchaser, the purchaser must return the part at the receivers expense to us for validation. Dispatch Times – We normally dispatch your order within 48 hours daily expect Sunday and Public Holidays. Goods are normally sent by Post or Toll Priority. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.